weBoost from Wilson Electronics 4G Smartphone Cradle Booster. The weBoost Drive 4G-S boosts 4G signal for Verizon, AT&T, and T-Mobile and 3G signal for all major U.S. carriers. Easy to install cell signal booster cradle that keeps your voice and data connected while on the road.
The new weBoost Drive 4G-S 470107 passes all the new FCC 2014 regulations. The weBoost Drive 4G-S is a cradle with a built-in 3G/4G cell signal booster that boosts 3G for all major U.S. carriers and 4G LTE for Verizon, AT&T, and T-Mobile all in a single cradle cell signal booster.
The cradle of the weBoost Drive 4G-S has adjustable wings that allow for most smartphones ranging from the smaller iPhones up to the large Samsung Notes. This allows you to place your smartphone in the cradle while driving to free your hands for more important things, like driving. While the smartphone is in the cradle the weBoost Drive 4G-S will boost the cell signal so your voice and data apps have the best possible signal.
The weBoost Drive 4G-S cradle has several mounting options that can be used to place the unit in your vehicle. The cradle is adjustable allowing for smart phone sizes from the smaller iPhones up to the larger Samsung Note. Now there is a place for you smartphone in your vehicle that also gives you a better cell signal whether you are in shadows poor signal areas in town or out in more remote areas in the country. This is an excellent option for individuals in hands-free driving locations.
The weBoost Drive 4G-S is easy to install. The weBoost 470107 kit comes with all necessary components; cell signal booster, exterior magnet mount antenna, vehicle power supply, multiple mounting options.
Exterior Antenna: The mini-magnet antenna is placed on the roof of the car. A good place for it is near the rear of the driver or passenger door. The antenna does not have to be located in the center of the roof, but rather about 6" to 12" from the edge of the roof. The antenna has about 10' of coax cable attached to it that will need to be connected to the Drive 4G-S booster. Run the coax down the door post, tucking it behind/under the plastic molding. Then run the coax under the seat, avoiding the seat sliding mechanisms that may cut the coax cable.
weBoost Drive 4G-S Booster: The Drive 4G-S booster has several mounting options that come in the kit along with an optional Cup Holder Mount available (purchased separately). Determine which method works best for you and your vehicle. One of our favorite methods for mounting the weBoost Drive 4G-S is the Cup Holder Mount because it is not permanent and allows the Drive 4G-S to easily be moved between vehicles. Usually console cup holders work best because of their open location.
Power Supply: A vehicle power supply comes with the kit that plugs into the 12v adapter in your console or dash.
This is a CONSUMER device.
BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your provider's consent. Most wireless providers consent to the use of signal boosters. Some providers may not consent to the use of this device on their network. If you are unsure, contact your provider. You MUST operate this device with approved antennas and cables as specified by the manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from any person. You MUST cease operating this device immediately if requested by the FCC or a licensed wireless service provider. WARNING. E911 location information may not be provided or may be inaccurate for calls served by using this device.
Please note, the four largest carriers - AT&T, T-Mobile, Verizon and Sprint - and more than 90 regional carriers have given blanket consent for use of all boosters certified to the new FCC standards.
This product hasn't received any reviews yet. Be the first to review this product!